Shenzhen Nokin Traffic Facilities Co., Ltd.

Road studs are available in different sizes, in aluminium, rigid ABS plastic or glass. They are designed to withstand heavy loads and severe shocks. They can be fitted with reflectors on either side, both sides or all sides. Reflectors can be or come in a variety of colours depending on their intended use. The most common colours are white, yellow and red. More advanced road studs have been introduced. In their place are solar road studs, which can run for many days on a single charge.

If a road studs cannot withstand a certain amount of pressure, it will easily shatter after being run over or impacted by a car, so naturally it will not work properly, so pressure resistance is a basic condition for a solar spike to work properly. But the problem is that the solar nail itself is an electronic product, including the electronic part, want to make the electronic part also has a high degree of pressure resistance is not an easy thing, so in general the solar nail pressure resistance than ordinary nail poor performance.

solar road marker installed on the road have problems with compression, and the products are either crushed or separated from top to bottom. This is actually caused by unreasonable structure.

Due to the high reflective brightness and good warning effect of the raised road signs, they are usually installed on both sides and the center line of the roadway. Under the illumination of the night lights, the outline of the roadway can be outlined, providing the driver with a clear and bright road driving environment.

Solar road studs are irradiated by sunlight during the day and converted into electricity by absorbing solar energy. When night falls, the LED lights in the solar road studs will start to work and emit constant or flashing lights for more than 10 hours. easy to install, easy to maintain, and does not need to lay circuits.

Smart Pedestrian Crossing Systems is the active light-emitting led solar road stud lights used on the sidewalk, also known as smart zebra crossing, In-Road Warning Light Systems. It is usually installed at one end of the crosswalk and emits a warning light through the solar road stud lights.

LED Solar road stud can be used on ordinary roads, country roads, and highways. They can point out slight bends or curvy roads that drivers would miss at night because headlights require a point of reference.They can be used to signal intersections without traffic lights, speed bumps and crosswalks so drivers can slow down or stop as needed.

The new solar road stud application system is called the Intelligent Pedestrian Crossing System, or smart zebra crossing system. It is worth noting that the solar road studs installed around crosswalks are generally flush type solar road studs. Drivers will pay attention to the pedestrians in front of them when they see the signal of solar road studs to reduce traffic accidents.